OK, I just bought a 4 gr DC with the DCII GCs grinder. I looked at the LM's, but the recovery time on the hot water from the steam tank sunk the line. I know its going to be awesome, but has anybody used / had problems with the DC Evolution ?.
Just curious.....

Thanks

Howard

Views: 2981

Reply to This

Replies to This Discussion

I don't know anything about prices for those machines.

Restarting a machine that has sat idle for a year might be immediately successful, or it might not. Hopefully the boiler was drained and it was cleaned thoroughly before its nap. If not, those are your first two steps. Your most likely issues will be the pump not firing up and/or lack of water flow due to mineral buildup at orifices.

If it is sitting there empty, just perform a good installation and give it a shot. If not, you probably want to call in a tech.

I'll elaborate briefly on the "perform a good installation" part. Verify that it is receiving adequate supply of properly-conditioned water. Verify that it has correct power and appropriately-sized wiring and breaker. If necessary, verify that the machine is set correctly for the actual voltage you have. Run a good (properly sloping) drain. The machine's pre-installation checklist (probably spec sheet) and installation manual are great resources. Once all that is finished, fire it up and see what happens.

I'd recommend calling in a tech, preferably one that works on Dalla Corte.

Good luck!


Q said:

Does anybody know how much the OCS and DTCS cost? Ive just bought a second hand Dalla corte evolution 3 groups, the machine has been sitting there for a year doing nothing, anyone got any tips for what I need to do before I turn on and use it again?
Thanks
Thanks for your info Brady. Appreciated your time.

Brady said:

I don't know anything about prices for those machines.

Restarting a machine that has sat idle for a year might be immediately successful, or it might not. Hopefully the boiler was drained and it was cleaned thoroughly before its nap. If not, those are your first two steps. Your most likely issues will be the pump not firing up and/or lack of water flow due to mineral buildup at orifices.

If it is sitting there empty, just perform a good installation and give it a shot. If not, you probably want to call in a tech.

I'll elaborate briefly on the "perform a good installation" part. Verify that it is receiving adequate supply of properly-conditioned water. Verify that it has correct power and appropriately-sized wiring and breaker. If necessary, verify that the machine is set correctly for the actual voltage you have. Run a good (properly sloping) drain. The machine's pre-installation checklist (probably spec sheet) and installation manual are great resources. Once all that is finished, fire it up and see what happens.

I'd recommend calling in a tech, preferably one that works on Dalla Corte.

Good luck!


Q said:

Does anybody know how much the OCS and DTCS cost? Ive just bought a second hand Dalla corte evolution 3 groups, the machine has been sitting there for a year doing nothing, anyone got any tips for what I need to do before I turn on and use it again?
Thanks

Reply to Discussion

RSS

Barista Exchange Partners

Barista Exchange Friends

Keep Barista Exchange Free

Are you enjoying Barista Exchange? Is it helping you promote your business and helping you network in this great industry? Donate today to keep it free to all members. Supporters can join the "Supporters Group" with a donation. Thanks!

Clicky Web Analytics

© 2024   Created by Matt Milletto.   Powered by

Badges  |  Report an Issue  |  Terms of Service